ELECINF344/381

Interactive web site of Télécom ParisTech's ELECINF344/ELECINF381 Robotics and Embedded Systems classes (a.k.a. ROSE, 2012 session).

Categories

RoseAce : FPGA programming and simulation

Because of our problem with the GPMC to communicate with the FPGA, we probably will command a new board. So, befoe buying a new board, we want to test if the FPGA programming (which does not use the GPMC but 4 GPIO to communicate with the JTAG ports of the FPGA) is working. So today,I worked on porting the software (jam STAPL )on out system (software which probably did not work on a system before I modify it). Now, the software is compiling and, tomorrow I will try to run it on the gumstix.

I began to debug the general system on the FPGA too but not a lot.

Jeremy Sauget

Possibly related posts:

  1. RoseAce : FPGA and gumstix communication
  2. RoseAce : FPGA and calcul
  3. RoseAce : FPGA
  4. PCB Command motor and FPGA programming
  5. Rose Ace : Architecture choice & distribution of work

Commentaires fermés.