RoseOnRails – Using the drill

Hi all,

After Yann, Valeh and I finished soldering the rail bends LEDs strips yesterday, we tackled the rails drilling.
We borrowed Telecom Robotics’ drill and got down to  work.

Here is a pic of Yann drilling … We drilled more than on hundred rails sections with 5 holes per section on average.


This operation was not easy to achieve, as we needed to drill holes precisely on the LEDs positions.
Hopefully, we will finish drilling and start setting the train circuit again today.

Electronically yours,


Noémie Bristol-Courgeon

Twitter LinkedIn 

Commentaires fermés.