[Kudly] Carrying on the PCB

Hello !

Tonight, we are going on the PCB.
We managed to finish the design on DesignView, and we are ready to start placing the elements and then routing them.

The camera and the Wifi modules are still to be integrated, but the pins are set on the design. The camera is linked to the microchip using DCMI and the Wifi using usart.

We finally decided to let down the CO2 sensor, because it is too expensive, it uses too much power and needs a 6V voltage which is over our battery voltage (3.7V).

Kudly’s PCB is coming :

Kudly_pcb

 

2 comments to [Kudly] Carrying on the PCB