[CyL3D] Motor Controller (Help needed)

We are taking the same mechanical parts as last year’s project. Now we are trying to get how much currennt the motor pulls in order to get a proper estimation of the consumption. 

I ran into a problem while testing the motor though. I don’t know how to use the motor controller (which is a Ezrun max 10 SCT). So I went looking for the documentation and found the very extensive 🙂 doc which just tells us to connect a receiver and everything should work fine. On our side we are trying to drive it with an arduino or something alike.

So far I know that the controller is driven by a 5V PWM, but I haven’t been able to make it work. So I would love to know how last year’s group made it work. 

Guillaume Soudais

Leave a Reply

Your email address will not be published. Required fields are marked *