[CyL3D] Schematics + routing continued

I’ve almost completed the schematics of all the LED panels. Once done, I will start placing and routing it.

I tried routing a small number of LEDs to check the estimations I made in the previous post. I forgot to take the soldering pad into account, so I only managed to place a LED each 3.2mm.

Anyway, this distance is too small and we risk soldering issues. Based on the vertical distance between last year’s SPIROSE LEDs, we will put a LED each 3.4mm (1.2mm between each).

Based on this, the LED panel will take roughly 11cm x 14cm. Since the PCB is 19cm x 19cm, we have plenty of space for other components. I will try to fully route one LED panel and its drivers to check if it is possible.

For now, here is an idea of how I was hopping to do the routing:

Technically, all components (except for the power supply, which I haven’t checked) fit in. What I need to figure out is if routing is feasible,

Leave a Reply

Your email address will not be published. Required fields are marked *