[bouLED] Designing the main board

I’m currently designing the main board. First, I had to create a routing table for the STM32H743VIT6 using one Alexis made as a base. We’re only able to have 5 SPIs, a SD card in 1-bit mode and an UART. Programming and debugging will be done over SWD.

The next step is the power supply, using an LT1765-3.3 buck converter. Using the datasheet, I started choosing ratings for its peripheral components, but it’s getting late so I’ll finish that tomorrow. Next step: drawing the schematic.

Leave a Reply

Your email address will not be published. Required fields are marked *