Ground control to RoseAce team

Ground transmission

We talked to Alexis this afternoon about ground transmission, and the solution we will finally go with is a mixture of those proposed in yesterday’s post. We will use wires soldered to the main PCB, and fix the GND wire to the axis with a sleeve clamp. Here is a diagram to present it:

@RoseAce : Could you please give us a hand ?

How many ball bearings did you use for VCC transmission in your project ? Thanks in advance for your help 🙂

2 Replies to “Ground control to RoseAce team”

  1. As far as i remember there were two ball bearings in the system, to keep our axis straight. However, only one was used to transmit power, it was the tricky part so we tried to reduce it.

Leave a Reply to Sibille Cancel reply

Your email address will not be published. Required fields are marked *