Reducto!

On Friday, I work on reducing the final PCB from 16×16 to 14×14. I have discovered two new things: to delete some route, you can use the tool “add partially selected nets”. You will gain some time until you realise that you delete all the GND and VCC nets… By chance, after spending one-hour routing again theses nets, thinking that you would have gained more time by going back in your git, you can use the command fanout that will route again these nets easily. So, the PCB is almost finished, I just need to adjust the board outline and we can concentrate on the code and the test PCB that may arrive one day.

Leave a Reply

Your email address will not be published. Required fields are marked *