I’ll be waiting for PCB

On Monday, I spend some times cleaning the PCB, by removing some resistor blocks and capacitors. We cannot take them out easily, so I have to clear them from the scheme one by one. I also move some multiplexers since they were very close to the route border. Now, we have a clean PCB but I need to clean a little the scheme.

I also continue to cut the oak plank for the final device, but I had some problems because of one of the planks which bends during the cutting. Two times. So we need to ship a new one.

Now, I will check that I generate a good HAL with STM32cubeMX and I will clean the scheme.

Leave a Reply

Your email address will not be published. Required fields are marked *